>

Hyundai Equus: Roof Side Molding Repair procedures

Second generation VI (2009–2024) / Hyundai Equus VI 2009-2024 Service Manual / Body (Interior and Exterior) / Body Side Molding / Roof Side Molding Repair procedures

Replacement

•	Put on gloves to protect your hands.

•	When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.

•	Take care not to scratch the body surface.

1.

Using a screwdriver or remover, remove the roof side molding (A).

•	Always replace the roof side molding to a new one.

2.

Install in the reverse order of removal.

•	Replace any damaged clips.

Body Side Molding

...

Front Wheel Guard Repair procedures

Replacement • Put on gloves to protect your hands. • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply prote ...

See also:

Hazard warning flasher
The hazard warning flasher serves as a warning to other drivers to exercise extreme caution when approaching, overtaking, or passing your vehicle. It should be used whenever emergency repairs a ...

Oil Pressure Switch Repair procedures
Inspection 1. Check the continuity between the terminal and the body with an ohmmeter. If there is no continuity, replace the oil pressure switch. 2. Check the continuity between the terminal ...

In-car Sensor Description and Operation
Description An in-car air temperature sensor is located in the heater control. The sensor contains a thermistor which measures the temperature of the cabin. The signal determined by the resistan ...

Categories

Hyundai Equus Manuals

© 2011-2024 Copyright www.heqmanual.com