>

Hyundai Equus: Front Wheel Guard Repair procedures - Body Side Molding - Body (Interior and Exterior) - Hyundai Equus VI 2009-2024 Service ManualHyundai Equus: Front Wheel Guard Repair procedures

Replacement
   
Put on gloves to protect your hands.
   
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Take care not to scratch the body surface.
1.
Remove the front tire.
2.
After loosening the mounting clips and screws, then remove the front wheel guard (A).

3.
Install in the reverse order of removal.
   
Replace any damaged clips.
    Roof Side Molding Repair procedures
    Replacement     • Put on gloves to protect your hands.     • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply prote ...

    Rear Wheel Guard Repair procedures
    Replacement     • Put on gloves to protect your hands.     • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply prote ...

    See also:

    Knock Sensor (KS) Description and Operation
    Description Knocking is a phenomenon characterized by undesirable vibration and noise and can cause engine damage. Knock Sensor (KS) is installed on the cylinder block and senses engine knockin ...

    Heater Core Repair procedures
    Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the heater and blower assembly. (Refer to Heater -"Heater Unit") 3. Remove the heater core cover (A) after loosening ...

    If engine doesn't turn over or turns over slowly
    1. Be sure the shift lever is in N (Neutral) or P (Park) and the emergency brake is set. 2. Check the battery connections to be sure they are clean and tight. 3. Turn on the interior light. If the ...

    Categories

    Hyundai Equus Manuals


    © 2011-2024 Copyright www.heqmanual.com