>
Inspection |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Open the sunglass case cover from the overhead console then
remove the 2 screws holding the overhead console. Disconnect the switch
connector (6P) and Map lamp connector (16P), and then remove the
overhead console lamp. |
3. |
Check for continuity between the terminals. If the continuity is not as specified, replace the sunroof switch. |
Roof Trim Assembly Components and Components Location
Component Location
1. Roof Trim Assembly
...
Gauges
Speedometer
The speedometer indicates the speed of the vehicle and is calibrated in miles
per hour (mph) and/or kilometers per hour (km/h).
✽ NOTICE
On the "User Settings Mode" ...
8LR Brake Control Solenoid Valve Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the E Module connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the res ...