>
Removal |
1. |
Remove the head lamp leveling unit linkage (A) from trailing arm. |
2. |
Loosen the mounting bolts (3EA) of automatic head lamp leveling unit assembly.
|
3. |
Remove the head lamp leveling unit connector. |
4. |
Remove the head lamp leveling unit assembly after removing the screws (2EA). |
Installation |
1. |
Connect the connector and install the head lamp leveling unit. |
2. |
Install the head lamp leveling unit linkage.
|
Inspection |
1. |
Ignition "ON". |
2. |
Turn on the head lamp switch. |
3. |
Check for operation. If the aim of the head lamps changes smoothly when the head lamp leveling switch is turned. |
4. |
If the operation does not work well, inspect the connector and terminals to be sure they are all making good contact.
If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
If the terminals look OK, go to step 5. |
5. |
Substitute with a known-good head lamp assembly and check for proper operation. |
Loss of a Smart Key
A maximum of three Smart Keys including Card Type Smart Key can be registered
to a single vehicle. If you happen to lose your Smart Key, you should immediately
take the vehicle and remaining key t ...
Fuel Tank Pressure Sensor (FTPS) Schematic Diagrams
Circuit Diagram
...
Underdrive Brake Control Solenoid Valve(UD/B_VFS) Description and Operation
Description
UD Clutch control solenoid valve is attached to the valve
body. This variable force solenoid valve directly controls the hydraulic
pressure inside the UD Clutch. ...