Hyundai Equus: Head Up Display Unit Repair procedures
Second generation VI (2009–2024) / Hyundai Equus VI 2009-2024 Service Manual / Body Electrical System / Head Up Display System / Head Up Display Unit Repair procedures
Second generation VI (2009–2024) / Hyundai Equus VI 2009-2024 Service Manual / Body Electrical System / Head Up Display System / Head Up Display Unit Repair procedures
| Removal |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the head up display bezel (A).
|
| 3. |
Remove the instrument cluster.
(Refer to Indicators And Guages - "Instrument Cluster")
|
| 4. |
Remove the head up display unit bracket (A) after loosening ther mounting nuts.
|
| 5. |
Remove the head up display unit (A).
|
| Installation |
| 1. |
Install the head up display unit. |
| 2. |
Install the head up display unit brackekt and instrumenet cluster. |
| 3. |
Install the head up display bezel. |
| 4. |
Connect the negative (-) battery terminal. |
Head Up Display Unit Schematic Diagrams
Circuit Diagram
...
See also:
Rear Glass Defogger Timer Repair procedures
Inspection
While operating the components, check whether the operations are normal as shown in the timing chart.
1.
Once ALT "L" is ON, if the defogger is switched ON, the defogger will stay ON f ...
Heater Control Unit Components and Components Location
Control Panel
Component
Connector Pin Function
Pin No.Connector AConnector B1GroundIgnition 22-FET (Gate)3Mode Control Actuator (Vent)FET (Drain Feedback)4Mode Control Actuator (Defrost)Sen ...
Camshaft Position Sensor (CMPS) Troubleshooting
Signal Waveform
This example shows a typical Crankshaft Position Sensor (CKPS) and Camshaft Position Sensor (CMPS) waveform at idle. ...
Categories
Hyundai Equus Manuals
© 2011-2024 Copyright www.heqmanual.com