>
When the wipers no longer clean adequately, the blades may be worn or cracked, and require replacement.
CAUTION
To prevent damage to the wiper arms or other components, do not attempt to move the wipers manually.
CAUTION
The use of a non-specified wiper blade could result in wiper malfunction and failure.
Front windshield wiper blade
For your convenience, move the windshield wiper blades to the service position as follows;
Turn off the engine.
Move the wiper switch to the single wiping (MIST) position within 20 seconds and hold the switch until the wiper blade is in the fully up position.
Type A
1. Raise the wiper arm.
CAUTION
Do not allow the wiper arm to fall against the windshield, since it may chip or crack the windshield.
2. Open the cover of the blade. Press the clip behind the wiper arm and remove the blade assembly downward.
3. Install the new blade assembly in the reverse order of removal.
4. Return the wiper arm on the windshield.
5. Turn the ignition switch to the ON position.
6. Move the wiper switch to any position and then to the OFF position.
Type B
1. Raise the wiper arm.
CAUTION
Do not allow the wiper arm to fall against the windshield, since it may chip or crack the windshield.
2. Turn the wiper blade clip. Then lift up the blade clip.
3. Push the clip (1) and push up the wiper arm (2).
4. Push down the wiper arm (3) and install the new blade assembly in the reverse
order of removal.
5. Return the wiper arm on the windshield.
Adaptive Front Lighting System Description and Operation
Description
AFLS Unit(ECU)
AFLS located in Cockpit Module is provided information of vehicle (steering wheel signal,vehicle speed, inclination of vehicle).
Based on provided information , it calc ...
Multi-view Camera Switch Repair procedures
Removal
Floor Console Switch
1.
Disconnect the negative (-) battery terminal.
2.
Remove the floor console upper cover.
(Refer to Body - "Floor Console Assembly")
3.
Disconnect the consol ...
Pantoscopic Camera Repair procedures
Removal
In case of bad quality or poor focus, be sure to check the camera lense surface condition and foreign materials.
Front Pantoscopic Camera
1.
Disconnect the negati ...