>
If the Smart Key does not operate normally, you can lock or unlock the door by using the mechanical key.
Mechanical Key of Conventional Smart Key
Depress and hold the release button (1) and remove the mechanical key (2). Insert the mechanical key in to the key hole on the door.
To reinstall the mechanical key, put the key into the hole and push it until a click sound is heard.
Mechanical Key of Card Type Smart Key
Push and hold the release lever (1) and remove the mechanical key (2). Insert the mechanical key in to the key hole on the door.
To reinstall the mechanical key, push and hold the release lever (1) and put the key into the hole and push it until a click sound is heard.
Side Impact Sensor (SIS) Description and Operation
Description
The Side Impact Sensor (SIS) system consists of two kinds of
side impact sensor which are installed at each center of the front door
module (left and right) and two rear sensors whi ...
Front Door Inside Handle Repair procedures
Replacement
1.
Remove the front door trim.
(Refer to Front Door - "Front Door Trim")
2.
Disconnect the front door inside handle lamp connector (A).
3.
After loosening the mounting screws ...
Crankshaft Position Sensor (CKPS) Troubleshooting
Signal Waveform
This example shows a typical Crankshaft Position Sensor (CKPS) and Camshaft Position Sensor (CMPS) waveform at idle. ...