When shift shock is occurred or parts related with the transmission are replaced, TCM learning should be performed.
In the following case, TCM learning is required.
| • |
Transmission assembly replacement |
| 1. |
TCM learning condition
| A. |
ATF temperature: 30 ~ 95°C (86 ~ 203°F) |
|
| 2. |
TCM learning procedure
| - |
Repeat the below shift pattern four times or more with stepping on the brake. 
|
| 1. |
Drive the vehicle through all gears at D range. Drive from
stop to 1st to 2nd to 3rd to 4th to 5th to 6th to 7th to 8th with
keeping fixed throttle open. |
| 2. |
Down shift from 8th to 7th, 7th to 6th, 6th to 5th, 5th to 4th, 4th to 3rd, 3rd to 2nd, 2nd to 1st. |
| 3. |
Repeat the above driving pattern four times or more.
Up-shift throttle open : 15 ~ 30% |
|
Description
Automatic transmission system relies on various measurement
data to determine the current control status and extrapolate the
necessary compensation values. These values are used to ...
See also:
Repair procedures
Component Replacement after Deployment
Before doing any SRS repairs, use the GDS to check for DTCs.
Refer to the Diagnostic Trouble Code list for repairing of the related
...
Components and Components Location
Components Location
1. ECM (Engine Control Module) 2. Manifold Absolute Pressure Sensor (MAPS)3. Intake Air Temperature Sensor (IATS) 4. Engine Coolant Temperature Sensor (ECTS) 5. Throttle ...
ON/OFF Solenoid Valve Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the E Module connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the res ...
Hyundai Equus: Repair procedures
Description and Operation
Schematic Diagrams