>
Removal |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the door trim (A) after loosening mounting screws.
(Refer to Body - "Front Door Trim") |
3. |
Remove the memory power seat control switch (A) after loosening connector and screws (2EA) from the door trim. |
Installation |
1. |
Install the memory power seat control switch after connecting the switch connector. |
2. |
Install the driver door trim. |
3. |
Install the negative (-) battery terminal. |
Crankshaft Position Sensor (CKPS) Schematic Diagrams
Circuit Diagram
...
Front wiper deicer
If your vehicle is equipped with the front wiper deicer, it will be operating
at the same time you operate the rear window defroster. ...
Rail Pressure Sensor (RPS) Repair procedures
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the RPS at idle and various engine speed.
ConditionOutput Voltage (V)Idle Approx. 1.21, ...