>
WARNING
Always wear appropriate shoes when operating your vehicle. Unsuitable shoes (high heels, slippers, ski boots, etc.) may interfere with your ability to use the brake and accelerator pedal.
1. Carry the smart key or leave it inside the vehicle.
2. Make sure the parking brake is firmly applied.
3. Place the shift lever in the P(Park) position.
4. Depress the brake pedal.
5. Press the Engine Start/Stop Button.
6. In extremely cold weather (below 0°F / -18°C) or after the vehicle has not been
operated for several days, let the engine warm up without depressing the accelerator.
Whether the engine is cold or warm, it should be started without depressing the accelerator.
CAUTION
If the engine stalls while you are in motion, do not attempt to move the shift lever to the P (Park) position. If traffic and road conditions permit, you may put the shift lever in the N(Neutral) position while the vehicle is still moving and press the Engine Start/Stop Button in an attempt to restart the engine.
WARNING
The engine will start by pressing the Engine Start/Stop Button, only when the smart key is in the vehicle. Never allow children or any person who is unfamiliar with the vehicle to touch the Engine Start/Stop Button or related parts.
✽ NOTICE
CAUTION
Do not press the Engine Start/Stop Button for more than 5 seconds except when the stop lamp fuse is disconnected.
Keep your car clean
The best way to prevent corrosion is to keep your car clean and free of corrosive
materials. Attention to the underside of the car is particularly important.
If you live in a high-corrosion area ...
Presure Switch Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the E Module connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the res ...
GAW (Gross axle weight)
This is the total weight placed on each axle (front and rear) - including vehicle
curb weight and all payload. ...