Vehicles have many control units that use more electricity.
These units control their own system based on information from diverse
sensors. It is important to have a stable power supply as there diverse
sensors giving a variety of information. Battery sensor is mounted on
battery (-) terminal. It transmits battery voltage, current, temperature
information to ECM. ECM controls generating voltage by duty cycle
based on these signals.
Removal
1.
Disconnect the battery negative (-) cable.
2.
Disconnect the battery sensor connector (A).
3.
Remove the battery negative (-) cable after removing the bolts (B).
Installation
...
See also:
Reprogramming a single HomeLink® button
To program a device to HomeLink® using a HomeLink® button previously trained,
follow these steps:
1. Press and hold the desired HomeLink® button. DO NOT release the button.
2. The indicator light ...
Head Lamps Repair procedures
Inspection
Head Lamp Relay Inspection
1.
Pull out the head lamp relay (Low) (A) from the engine compartment relay box.
A : Head lamp(Low) relay
2.
Check for continuity between terminals. The ...
Schematic Diagrams
Schematic Diagram
...