With the vehicle on level ground, check the fluid level in the power steering reservoir periodically. The fluid should be between MAX and MIN marks on the side of the gauge at the normal temperature.
Before adding power steering fluid, thoroughly clean the area around the reservoir cap to prevent power steering fluid contamination.
If the level is low, add fluid to the MAX level.
In the event the power steering system requires frequent addition of fluid, the vehicle should be inspected by an authorized EQUUS dealer.
CAUTION
Use only the specified power steering fluid. (Refer to "Recommended lubricants or capacities" in section 8.)
Trailing Arm Repair procedures
Removal
1.
Remove the rear wheel & tire.
Tightening torque :
90.0 ~ 110.0 N.m(9.0 ~ 11.0 kgf.m, 65.0 ~ 80.0 lb-ft)
2.
Disconnect the trailing arm (A) from the rear axle by loosening ...
Seat Belt Buckle Switch (BS) Components and Components Location
Components
...
Start/Stop Button Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad center panel.
(Refer to Body - "Crash Pad Center Panel")
3.
Remove the start/stop button connector (A) fro ...