>
Circuit Diagram |
Blind Spot Detection Indicator Repair procedures
Removal
Blind Spot Detection Warnig Indicator
1.
Disconnect the negative (-) battery terminal.
2.
Remove the mirro (A).
Installation
Blind Spot Detection Warnig Indicator
1.
Install the ...
Rear Stabilizer Bar Repair procedures
Removal
1.
Remove the rear wheel and tire (A) from rear hub .
Tightening torque:
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)
•
Be careful not to damage t ...
Maintenance under severe usage conditions
The following items must be serviced more frequently on cars normally used under
severe driving conditions. Refer to the chart below for the appropriate maintenance
intervals.
R : Replace
I : I ...