>
The sensor detects distance to the vehicle ahead.
If the sensor is covered with dirt or other foreign matter, the vehicle to vehicle distance control may not operate correctly.
Always keep the sensor clean.
SCC (Smart cruise control) malfunction indicator
The warning message/ indicator illuminates when the vehicle to vehicle distance control system is not functioning normally.
Have the system checked by an authorized EQUUS dealer.
CAUTION
To convert to cruise control mode:
The driver may choose to only use the cruise control mode (speed control function) by doing as follows:
1.Turn the smart cruise control system on (the cruise indicator light will be
on but the system will not be activated).
2.Pull the distance to distance switch for more than 2 seconds.
3.Choose between "Smart cruise control(SCC) mode" and "Cruise control(CC) mode".
WARNING
When using the cruise control mode, you must manually access the distance to other vehicles as the system will not automatically brake to slow down for other vehicles.
Knee Airbag (KAB) Module Repair procedures
Removal
1.
Disconnect the battery negative cable and wait for at least three minutes before beginning work.
2.
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel")
...
Compressor Repair procedures
Removal
1.
If the compressor is marginally operable, run the engine at
idle speed, and let the air conditioning work for a few minutes, then
shut the engine off.
2.
Disconnect the negative ...
This device complies with Part 15 of the FCC rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that
may c ...