>

Hyundai Equus: Front Door Outside Handle Repair procedures

Second generation VI (2009–2024) / Hyundai Equus VI 2009-2024 Service Manual / Body (Interior and Exterior) / Front Door / Front Door Outside Handle Repair procedures

Replacement

1.	Remove the hole plug (B).

2.

After loosening the mounting bolt, then remove the front door outside handle cover (A).

Tightening torque :

6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)

3.	Remove the front door outside handle (A) by sliding it rearward.

4.	Disconnect the front door outside handle connector (A).

5.

Install in the reverse order of removal.

•	Make sure the connector is connected properly.

•	Make sure the door locks/unlocks and opens/closes properly.

Front Door Outside Handle Components and Components Location

Component Location 1. Front door outside handle ...

Rear Door

...

See also:

Camshaft Position Sensor (CMPS) Description and Operation
Description Camshaft Position Sensor (CMPS) is a hall sensor and detects the camshaft position by using a hall element. It is related with Crankshaft Position Sensor (CKPS) and detects the pisto ...

Output Speed Sensor Repair procedures
Inspection 1. Check signal waveform of output speed sensor using the GDS. Specification: Refer to "Signal Wave Form" section. ...

Resetting the Sunroof
If the battery has been discharged or disconnected, or if the related fuse has been replaced or disconnected, reset the Sunroof as follows: 1. The Engine Start/Stop Button must be in the ON positio ...

Categories

Hyundai Equus Manuals

© 2011-2024 Copyright www.heqmanual.com