• |
Put on glove to protect your hands. |
|
• |
Take care not to scratch the interior trims and other parts. |
|
1. |
Remove the roof trim.
(Refer to Roof Trim - "Roof Trim Assembly") |
2. |
Remove the sunroof glass.
(Refer to Sunroof - "Sunroof Glass") |
3. |
Loosen the mounding bolts, remove the assist handle mounting bracket (A). |
4. |
Disconnect the drain tubes (A). |
5. |
After loosening the mounding bolt and nuts, remove the sunroof assembly (B).
• |
Take care not to scratch the interior trims and other parts. |
|
Tightening torque :
(C) : 7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
(D) : 3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)
|
|
6. |
Install in the reverse order of removal.
• |
Make sure to initialize the motor. |
|
|
Replacement
1.
Open the glass fully.
2.
Disconnect the deflector link (A) and spring (B) from the frame, and then remove the deflector (C).
3.
Install in the reverse order of removal. ...
Replacement
1.
Remove the sunroof assembly.
(Refer to Sunroof - "Sunroof Assembly")
2.
After loosening the mounting screw, then remove the drip link (A) and sunshade stopper (B).
3.
Remov ...
See also:
Smart Key Receiver Repair procedures
Removal
1.
Disconnect the negatiev (-) battery terminal.
2.
Remove the glove box housing.
(Refer to Body - "Glove Box Housing")
3.
Remove the RF receiver (B) after disconnecting the conne ...
Blind Spot Detection Unit Schematic Diagrams
Circuit Diagram
...
Parking assist system
The parking assist system assists the driver during movement of the vehicle by
chiming if any object is sensed within the distance of 39 in (100 cm) in front or
47 in (120 cm) behind the vehicle ...