>
Hyundai Equus Manuals

Hyundai Equus: Repair procedures - Floor Carpet - Body (Interior and Exterior) - Hyundai Equus VI 2009-2024 Service ManualHyundai Equus: Repair procedures

Second generation VI (2009–2024) / Hyundai Equus VI 2009-2024 Service Manual / Body (Interior and Exterior) / Floor Carpet / Repair procedures

Replacement
   
•
Put on gloves to protect your hands.
   
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Remove the front seat assembly.
(Refer to Front Seat - "Front Seat Assembly")
2.
Remove the rear seat cushion assembly.
(Refer to Rear Seat - "Rear Seat Assembly")
3.
Remove the rear seat back assembly.
(Refer to Rear Seat - "Rear Seat Assembly")
4.
Remove the rear seat frame assembly.
(Refer to Rear Seat - "Rear Seat Frame Assembly")
5.
Remove the front pillar trim.
(Refer to Interior Trim - "Front Pillar Trim")
6.
Remove the center pillar lower trim.
(Refer to Interior Trim - "Center Pillar Trim")
7.
Remove the floor console assembly.
(Refer to Floor Console - "Floor Console Assembly")
8.
Using a screwdriver or remover, remove the frame id blanking bracket (A).
9.
Remove the accelerator pedal.
(Refer to Engine Control/Fuel System - "Accelerator Pedal")
10.
Remove the floor carpet assembly (B).
11.
Remove the tunnel pad (C).
12.
Install in the reverse order of removal.
   
•
Replace any damage clips.

1. Frame id blanking bracket
2. Floor carpet assembly
3. Tunnel pad

    Floor Carpet
    ...

    Front Bumper
    ...

    See also:

    Sedan Under Body
    Under body Projected dimensions Tooling hole (O25)Front sub frame mounting pipe (O25)Tooling hole (O14)Front sub frame mounting pipe (O27)Tooling hole (O15)Tooling & paint drain hole (O6.6 ...

    Front Pillar Trim Repair procedures
    Replacement     • Put on gloves to protect your hands.     • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protec ...

    Starter Relay Repair procedures
    Inspection 1. Disconnect the battery negative terminal. 2. Remove the fuse box cover. 3. Remove the starter relay(A). 4. Using an ohmmeter, check that there is continuity between each ...

    Categories

    Hyundai Equus Manuals


    © 2011-2024 Copyright www.heqmanual.com