>

Hyundai Equus: Radiator Grill Repair procedures

Second generation VI (2009–2025) / Hyundai Equus VI 2009-2025 Service Manual / Body (Interior and Exterior) / Front Bumper / Radiator Grill Repair procedures

Replacement

•	Put on gloves to protect your hands.

•	When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.

•	Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.

•	Take care not to bend or scratch the trim and panels.

1.	Remove the front bumper cover. (Refer to Front Bumper - "Front Bumper Cover")

2.	Remove the radiator grill center bracket mounting rivet and then loosen the screws.

3.	Remove the radiator grill center bracket (A).

4.	Loosen the radiator grill mounting screws.

5.	Unlock the lock pins (B) by pushing it up with a screwdriver or remover and then remove the radiator grill (A).

6.

Install in the reverse order of removal.

•	Make sure the connector is connected properly.

•	Replace any damage clips.

Radiator Grill Components and Components Location

Component Location 1. Radiator grill ...

Rear Bumper

...

See also:

Intake Manifold Repair procedures
Removal and Installation 1. Disconnect the negative terminal (A) from the battery. Tightening torque : 3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft) 2. Remove the engine room cover (A ...

Electric Parking Brake (EPB) Schematic Diagrams
Circuit Dragram ...

Rail Pressure Sensor (RPS) Description and Operation
Description Rail Pressure Sensor (RPS) is installed on the delivery pipe and measures the instantaneous fuel pressure in the delivery pipe. The sensing element (Semiconductor element) built in ...

Categories

Hyundai Equus Manuals

© 2011-2025 Copyright www.heqmanual.com