>

Hyundai Equus: Rear Seat Cushion Cover Repair procedures

Second generation VI (2009–2025) / Hyundai Equus VI 2009-2025 Service Manual / Body (Interior and Exterior) / Rear Seat / Rear Seat Cushion Cover Repair procedures

Replacement

[LH]

•	Put on gloves to protect your hands.

•	When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.

•	Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.

•	Take care not to bend or scratch the trim and panels.

1.	Remove the rear seat cushion assembly [LH]. (Refer to Rear Seat - "Rear Seat Assembly")

2.	Remove the protector (A) located in the rear part of the rear seat cushion.

3.	After removing the hog-ring clips on the rear of seat cushion cover and remove the rear seat cushion cover (A).

4.	Install in the reverse order of removal.

Rear Seat Cushion Cover Components and Components Location

Component Location 1. Rear seat cushion cover [LH]2. Rear seat cushion cover [RH] ...

Rear Seat Frame Assembly Components and Components Location

Component Location 1. Rear seat frame assembly [LH]2. Rear seat frame assembly [RH] ...

See also:

Certification label
The certification label is located on the driver's door sill at the center pillar. This label shows the maximum allowable weight of the fully loaded vehicle. This is called the GVWR (Gross ...

27 Brake Control Solenoid Valve Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Disconnect the E Module connector. 3. Measure resistance between sensor signal terminal and sensor ground terminal. 4. Check that the res ...

Starter Relay Repair procedures
Inspection 1. Disconnect the battery negative terminal. 2. Remove the fuse box cover. 3. Remove the starter relay(A). 4. Using an ohmmeter, check that there is continuity between each ...

Categories

Hyundai Equus Manuals

© 2011-2025 Copyright www.heqmanual.com