>

Hyundai Equus: Rear Seat Belt Retractor Repair procedures

Second generation VI (2009–2024) / Hyundai Equus VI 2009-2024 Service Manual / Body (Interior and Exterior) / Rear Seat Belt / Rear Seat Belt Retractor Repair procedures

Replacement

•	When installing the belt, make sure not to damage the retractor.

1.	Remove the rear package tray trim. (Refer to Interior Trim - "Rear Package Tray Trim")

2.

After loosening the mounting bolt, then remove the rear seat belt retractor (A).

Tightening torque :

39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)

3.

After loosening the retractor (A) mounting bolt, remove the rear seat belt (B).

Tightening torque :

39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)

4.

Install in the reverse order of removal.

•	Make sure the connector is plugged in properly.

•	Replace any damaged clips.

Rear Seat Belt Retractor Components and Components Location

Component Location 1. Rear seat belt retractor ...

Rear Center Seat Belt Retractor Components and Components Location

Component Location 1. Rear center seat belt retractor ...

See also:

Cluster Ion Generator Description and Operation
Description The cluster ion generator makes disinfection and decomposition of bad smell from the air-conditioner or inflow air. And it cleans the inside air of a vehicle. When the ignition swi ...

Side Impact Sensor (SIS) Components and Components Location
Components ...

Transmission Control Module (TCM) Repair procedures
Inspection TCM Problem Inspection Procedure 1. TEST TCM GROUND CIRCUIT: Measure resistance between TCM and chassis ground using the backside of TCM harness connector as TCM side check poin ...

Categories

Hyundai Equus Manuals

© 2011-2024 Copyright www.heqmanual.com