>

Hyundai Equus: Steering Wheel Remote Controller (SWRC) Troubleshooting - Premium AVN System - Body Electrical System - Hyundai Equus VI 2009-2024 Service ManualHyundai Equus: Steering Wheel Remote Controller (SWRC) Troubleshooting

Initialization and Troubleshooting Procedures
1.
Initialization Procedure
: Disconnect (connector or battery) for 30 seconds (time required for internal condenser discharge), then reconnect the power.
2.
Troubleshooting Procedure
Location
Classification
Failure Symptom
Inspection Items
Detailed Checklist
Related Parts
Upper Left
Button
Button does not work
Visual check on all buttons in the same module. Check on the connection status of the connector.
Check for a wedged button.
Check button status using diagnostic tool (GDS).
Upper left button, wire harness, connector
Upper Right
Button
(General Spec)
Button does not work
Visual check on all buttons in the same module. Check on the connection status of the connector.
Check for a wedged button.
Check button status using diagnostic tool (GDS).
Upper right button, wire harness, connector
Button
(Haptic Spec)
Button does not work
Visual check on all buttons in the same module. Check on the connection status of the connector.
Check for a wedged button.
Check button status using diagnostic tool (GDS).
Upper right button, wire harness, connector
Rotary Unit
(Haptic Spec)
Cannot move from the Stop menu on the instrument cluster after an abnormal rotation occurs.
Inspection using diagnostic tool (GDS).
Check belt and sensor status using diagnostic tool (GDS).
Belt, Sensor
Lower Left
Button
Button does not work
Visual check on all buttons in the same module. Check on the connection status of the connector. Visual check on the button on the top left
Check for a wedged button.
Check button status using diagnostic tool (GDS). If the upper left button is pressed, no button operates except for LDWS.
Lower left button, upper left button, wire harness, connector
Lower Right
Button
Button does not work
Visual check on all buttons in the same module. Check on the connection status of the connector.
Check for a wedged button.
Check button status using diagnostic tool (GDS).
Lower right button, wire harness, connector

    Steering Wheel Remote Controller (SWRC) Repair procedures
    Inspection 1. Check for resistance between terminals in each switch position. [LH Top (Audio)] SwitchConnectorterminalResistance(±5%)Volume Down6-7240 xSeek Down510 xMode940 xVolume Up1.69 kxSee ...

    AVN Antenna Components and Components Location
    Components ...

    See also:

    Rear Package Tray Trim Repair procedures
    Replacement     • Put on gloves to protect your hands.     • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protec ...

    Camshaft Position Sensor (CMPS) Troubleshooting
    Signal Waveform This example shows a typical Crankshaft Position Sensor (CKPS) and Camshaft Position Sensor (CMPS) waveform at idle. ...

    Repair procedures
    Inspection Tolerance Compensation Tolerance compensation compensates for the error margins of Multi-view video that occur due to the installation tolerance when the four cameras that comprise ...

    Categories

    Hyundai Equus Manuals


    © 2011-2024 Copyright www.heqmanual.com