Hyundai Equus: Rear Glass Defogger Switch Repair procedures
| Removal |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Using a screwdriver or plastic panel remover, remove the cluster fascia upper panel (A).
|
| 3. |
Using a screwdriver or plastic panel remover, remove the center fascia upper panel (A).
|
| 4. |
Disconnect the heater control unit connector (A), clock and SSB connector (B).
|
| 5. |
After loosening the screws, remove the heater control unit (A) from the center fascia upper panel.
|
| Installation |
| 1. |
Install the heater control unit to the center fascia upper panel. |
| 2. |
Install the center fascia upper panel. |
| 3. |
Install the cluster fascia upper panel. |
| Inspection |
| 1. |
The rear window defogger switch inputs can be checked using the GDS. |
| 2. |
To check the input value of rear window defogger switch, select option "IPM". |
| 3. |
Select option "Input/output monitoring".
|
| 4. |
To check the input value of rear window defogger switch in force mode, select option "ACTUATION TEST".
|
Rear Glass Defogger Printed Heater Repair procedures
Inspection
Wrap tin foil around the end of the voltmeter test lead to
prevent damaging the heater line. Apply finger pressure on the tin foil,
moving the tin foil along th ...
Rear Glass Defogger Relay Repair procedures
Inspection
1.
Disconnect the negative (-) battery terminal.
2.
Remove the rear glass defogger relay (A) from the engine room relay box.
3.
There should be continuity between the No.87 and ...
See also:
Rail Pressure Sensor (RPS) Repair procedures
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the RPS at idle and various engine speed.
ConditionOutput Voltage (V)Idle Approx. 1.21, ...
8LR Brake Control Solenoid Valve Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the E Module connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the res ...
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that
may c ...