>
Heated Oxygen Sensor (HO2S) Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the HO2S connector.
3.
Measure resistance between the HO2S terminals 3 and 4.
4.
Check that the resistance is within the speci ...
Heated Oxygen Sensor (HO2S) Troubleshooting
Signal Waveform
Fig.1) The signal waveforms of front HO2S(the upper) and heater(the lower) at idle
Fig.2) The signal waveforms of rear HO2S(the upper) and heater(the lower) at idle
Fig.3) Typical ...
4&OD Clutch Control Solenoid Valve Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the E Module connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the res ...