>
Check the pads for excessive wear, discs for run out and wear, and calipers for fluid leakage.
Spliter Unit Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the floor console.
(Refer to Body - "Floor Console Assembly")
3.
Remove the spliter unit (A) after disconnecting the con ...
Heated Oxygen Sensor (HO2S) Troubleshooting
Signal Waveform
Fig.1) The signal waveforms of front HO2S(the upper) and heater(the lower) at idle
Fig.2) The signal waveforms of rear HO2S(the upper) and heater(the lower) at idle
Fig.3) Typical ...
Specifications
Specifications
Front air strut
ItemsSpecificationAir spring volume at design position1.78xMaximum other bellow diameter118 mmBurst pressure31.5 barMinimum operating temperature-40°CMaximum operati ...