>

Hyundai Equus: Thermostat Troubleshooting - Cooling System - Engine Mechanical System - Hyundai Equus VI 2009-2024 Service ManualHyundai Equus: Thermostat Troubleshooting

Troubleshooting
Symptoms
Possible Causes
Remedy
Coolant leakage
From the thermostat gasket
Check the mounting bolts
Check the torque of the mounting bolts
Retighten the bolts and check leakage again.
Check the gasket for damage
Check gasket or seal for damage
Replace gaskets and reuse the thermostat.
Cooled excessively
Low heater performance (cool air blowed-out)
Thermogauge indicates 'LOW'
Visually check after removing the radiator cap.
Insufficient coolant or leakage.
After refilling coolant, recheck.
GDS check&Starting engine
Check DTCs
Check connection of the fan clutch or the fan motor.
x If the fan clutch is always connected, there will be a noise at idle.
Check the engine coolant sensor, wiring and connectors.
Replace the componants.
Remove the thermostat and inspect
Check if there are dusts or chips in the thermostat valve.
Check adherence of the thermostat.
Clean the thermostat valve and reuse the thermostat.
Replace the thermostat, if it doesn't work properly.
Heated excessively
Engine overheated
Thermogauge indicates 'HI'
Visually check after removing the radiator cap.
Insufficient coolant or leakage.
x Be careful when removing a radiator cap of the overheated vehicle.
Check air in cooling system.
After refilling coolant, recheck.
Check the cylinder head gaskets for damage and the tightening torque of the mounting bolts.
GDS check&Starting engine
Check DTCs
Check the fan motor performance as temperature varies.
Check if the fan clutch slips.
Check the water pump adherence or impeller damaged.
Check the engine coolant sensor, wiring and connectors.
Check the fan motor, the relay and the connector.
Replace the fan clutch, if it doesn't work properly.
Replace the water pump, if it doesn't work properly.
Immerse the thermostat in boiling water and inspection.
After removing the thermostat, check it works properly.
x Check the thermostat opens at the valve opening temperature.
Replace the thermostat, if it doesn't work properly.

    Thermostat Repair procedures
    Removal and Installation 1. Disconnect the negative terminal (A) from the battery. Tightening torque : 4.0~6.0N.m (0.4~0.6kgf.m, 3.0~4.4lb-ft) 2. Remove the air duct, air intak hose and ...

    Lubrication System
    ...

    See also:

    Rear Assist Arm Repair procedures
    Removal 1. Remove the rear wheel and tire (A) from rear hub . Tightening torque: 88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)     • Be careful not to damage t ...

    Power Seat Module(PSM) Description and Operation
    Description 1. Power Seat Module (PSM) (1) Main features ItemDescriptionInstallation location Lower section of the driver side seatComponent configuration 1. Embedded with CAN Communication ...

    Front Hub / Knuckle / Tone Wheel Repair procedures
    Replacement 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A) from front hub .     Be ca ...

    Categories

    Hyundai Equus Manuals


    © 2011-2024 Copyright www.heqmanual.com