Removal |
1. |
Turn the ignition switch OFF and disconnect the negative (-) battery cable. |
2. |
Remove the service cover (A). |
3. |
Disconnect the fuel tank pressure sensor connector (A) and the canister close valve connector (B). |
4. |
Disconnect the vapor tube quick-connector (C), the vapor hose quick-connector (D), and the vapor hose (E) from the canister. |
5. |
Remove the fuel tank pressure sensor hose clip (F). |
6. |
Remove the canister after removing the installation bolt (G). |
Inspection |
1. |
Check for the following items visually.
A: Canister - Atmosphere (via Fuel Tank Air Filter)
B: Canister - Fuel Tank
C: Canister - Intake Manifold
|
Installation |
Canister installation bolt :
3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~4.3 lb-ft)
Canister cover installation bolt :
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~8.7 lb-ft)
Canister protector installation bolt :
19.6 ~ 29.4 N.m (2.0 ~ 3.0 kgf.m, 14.5 ~21.7 lb-ft) |
Yaw-rate and Lateral G Sensor Description and Operation
Description
The ESP system is the shorten word of Electronic Stability
Control system. This system recognizes a critical driving condition by
Yaw-rate sensor, Lateral acceleration sensor and St ...
Owner maintenance schedule
When you stop for fuel:
Check the engine oil level.
Check coolant level in coolant reservoir.
Check the windshield washer fluid level.
Look for low or under-inflated tires.
WARNING
Be ca ...
Power Door Lock Actuators Repair procedures
Inspection
Front Door Lock Module Inspection
1.
Remove the front door trim.
(Refer to Body - "Front Door Trim")
2.
Remove the front door module.
(Refer to Body - "Front Door Module")
3.
...