>
Inspection |
1. |
Connect the GDS on the Data Link Connector (DLC). |
2. |
Measure the output voltage of the MAPS at idle and IG ON.
|
EPB Switch Repair procedures
Removal
1.
Turn ignition switch off and disconnect the battery (-) cable from the battery
2.
Remove the driver side crash pad side cover.
(Refer to Body - "Crash Pad")
3.
Remove the cra ...
Checking the engine oil level
1. Be sure the vehicle is on level ground.
2. Start the engine and allow it to reach normal operating temperature.
3. Turn the engine off and wait for a few minutes (about 5 minutes) for the oil ...
4&OD Clutch Control Solenoid Valve Description and Operation
Description
4&OD Clutch control solenoid valve is attached to the
valve body. This variable force solenoid valve directly controls the
hydraulic pressure inside the 4&OD Clutch. ...