>
Inspection |
1. |
Turn ignition switch OFF. |
2. |
Disconnect the E Module connector. |
3. |
Measure resistance between sensor signal terminal and sensor ground terminal. |
4. |
Check that the resistance is within the specification. |
Filter replacement
It must be replaced when necessary, and should not be washed.
You can clean the filter when inspecting the air cleaner element. Clean the filter
by using compressed air.
Main air cleaner
1. ...
Head Up Display Unit Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the head up display bezel (A).
3.
Remove the instrument cluster.
(Refer to Indicators And Guages - "Instrument Cluster") ...
Tilt Steering/Telescope Steering
Adjust the steering wheel angle (2) and position (3) with the knob (1) on the
steering column. Move the steering wheel, so it points toward your chest, not toward
your face. Make sure you can ...