Four air spring solenoid valves (‘-’ control) and one
ambient solenoid valve are embedded inside this solenoid valve block as
shown in the circuit diagram below. When connecting the air tube to the
solenoid valve block, carefully check the color dot which is marked on
the valve and tube so that all colors should be matched each other.
The pressure sensor is built in the solenoid valve block so
that it detects the internal pressure when lifting or lowering the
vehicle height. Also it senses the pressure of reservoir tank every 30
minutes when the vehicle is running.
Components
1. Connected to air tube2. Bracket3. Connector
...
Circuit diagram
1.
Solenoid valve connector terminal
2.
Solenoid valve terminal function
TerninalFunction1Air spring valve FL2Ambiance valve3Air spring valve RR4Air spring valve RL5Solenoid ...
See also:
Injector Troubleshooting
Signal Waveform
...
Components and Components Location
Component Location
1 . Front PAS sensor (4EA)2 . Rear PAS sensor (4EA)3. Indicator (warning information displayed on LCD)4 . Parking Assist System (PAS) switch5 . Body Control Module (BCM)6. Clus ...
Do not let your parking brake freeze
Under some conditions your parking brake can freeze in the engaged position.
This is most likely to happen when there is an accumulation of snow or ice around
or near the rear brakes or if the bra ...