>

Hyundai Equus: ESP Control Unit Components and Components Location - ESP(Electronic Stability Program) System - Brake System - Hyundai Equus VI 2009-2024 Service ManualHyundai Equus: ESP Control Unit Components and Components Location

Components
[Standard]

1. Front-right tube
2. Rear-left tube
3. Rear-right tube
4. Front-left tube
5. MC2
6. MC1
7. ESP control module connector
8. ESP control module(HECU)
9. ESP HECU bracket

[Premium]

1. Front-right tube
2. Rear-left tube
3. Rear-right tube
4. Front-left tube
5. MC2
6. MC1
7. ESP control module connector
8. ESP control module(HECU)
9. ESP HECU bracket

    Troubleshooting
    Failure Diagnosis 1. In principle, ESP and TCS controls are prohibited in case of ABS failure. 2. When ESP or TCS fails, only the failed system control is prohibited. 3. However, when the ...

    ESP Control Unit Repair procedures
    Removal 1. Turn ignition switch OFF and disconnect the negative (-) battery cable 2. Remove the Engine room junction box after removing the cover. 3. Disconnect the brake tubes from the HE ...

    See also:

    Heater & A/C Control Unit Repair procedures
    Self Diagnosis 1. Self-diagnosis process 2. How to read self-diagnostic code After the display panel blinks three times every 0.5 second, the corresponding fault code blinks on the setup te ...

    4&OD Clutch Control Solenoid Valve Repair procedures
    Inspection 1. Turn ignition switch OFF. 2. Disconnect the E Module connector. 3. Measure resistance between sensor signal terminal and sensor ground terminal. 4. Check that the res ...

    TPMS Receiver Description and Operation
    Description 1. Mode (1) Virgin State A. The receiver as a sole part is shipped in this state. Replacement parts should therefore arrive in this state. B. In this state, there is no Auto-Lo ...

    Categories

    Hyundai Equus Manuals


    © 2011-2024 Copyright www.heqmanual.com