>

Hyundai Equus: Trunk Lid Back Panel Repair procedures

Second generation VI (2009–2024) / Hyundai Equus VI 2009-2024 Service Manual / Body (Interior and Exterior) / Trunk Lid / Trunk Lid Back Panel Repair procedures

Replacement

•	Put on gloves to protect your hands.

•	When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.

•	Take care not to scratch the body surface.

1.	Remove the trunk lid trim. (Refer to Trunk Lid - "Trunk Lid Trim")

2.	Loosen the mounting nut, remove the trunk lid panel (A).

3.

Install in the reverse order of removal.

•	Make sure the connector are connected in properly.

•	Replace any damaged clips.

Trunk Lid Back Panel Components and Components Location

Component Location 1. Trunk lid back panel ...

Trunk Lid Weatherstrip Repair procedures

Replacement 1. Remove the trunk lid weatherstrip (A). • Do not apply sealant to the body. 2. Install in the reverse order of removal. • ...

See also:

Repair procedures
Component Replacement after Deployment Before doing any SRS repairs, use the GDS to check for DTCs. Refer to the Diagnostic Trouble Code list for repairing of the related ...

Start-Up
You can start the engine without inserting the key. For detailed information refer to the Engine Start/Stop Button in section 5. CAUTION To prevent damaging the Smart Key : Keep the Smart Key ...

Over Pressure Valve (OPV) Repair procedures
Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Release the residual pressure in fuel line. (Refer to Fuel Delivery System -"Release Residual Pressu ...

Categories

Hyundai Equus Manuals

© 2011-2024 Copyright www.heqmanual.com