>
Replacement |
1. |
Remove the front door trim.
(Refer to Front Door - "Front Door Trim") |
2. |
Disconnect the front door inside handle lamp connector (A). |
3. |
After loosening the mounting screws, then remove the front door inside handle (B). |
4. |
Install in the reverse order of removal.
|
Muffler Repair procedures
Removal
1.
Disconnect the rear oxygen sensor (HO2S) connector (A) on LH and RH side.
2.
Remove the front muffler (A) on LH and RH side.
Tightening torque :
39.2 ~ 58.8 N.m (4.0 ~ 6.0 kgf.m ...
Troubleshooting
Troubleshooting
Ignition System
SymptomSuspect AreaRemedyEngine will not start or is hard to start (Cranks OK)Ignition lock switchInspect ignition lock switch, or replace as requiredIgnition c ...
Electric Parking Brake (EPB) Components and Components Location
Components
1. EPB2. Bracket No.13. Bracket No.24. EPB Extension wiring harness5. Parking brake cable
...