>
Replacement |
1. |
Remove the front door trim.
(Refer to Front Door - "Front Door Trim") |
2. |
Remove the door outside belt weatherstrip. |
3. |
Remove the plug hole (A).
|
4. |
Remove the outside belt weatherstrip (C). |
5. |
Carefully adjust the front door window glass (B) until you
can see the bolts, then loosen them. Separate the glass from the glass
run and carefully pull the glass out through the window slot.
|
6. |
Install in the reverse order of removal.
|
Headlight, position light, turn signal light, side marker light and front fog
light bulb replacement
(1) Position light
(2) Headlight (High)
(3) Headlight (Low)
(4) Front side marker light
(5) Front turn signal light
(6) Front fog light
1. Open the hood.
2. Disconnect the negative battery ...
Troubleshooting
Troubleshooting
SymptomPossible causeRemedyOne lamp does not light(all exterior)Bulb or LED burned outReplace bulb or lamp assemblySocket, wiring or ground faultyRepair if necessaryHead lamps do ...
Heater Unit Components and Components Location
Component Location
Components
1. Heater Case (Left)2. Vent Door (Left)3. Temperature Door (Left)4. Floor Door (Left)5. Console Temperature Control Actuator (A) 6. Console Temperature Lever7. Con ...