>

Hyundai Equus: Fuel Pump Control Module (FPCM) Repair procedures - Fuel Delivery System - Engine Control/Fuel System - Hyundai Equus VI 2009-2024 Service ManualHyundai Equus: Fuel Pump Control Module (FPCM) Repair procedures

Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Check the output voltage of fuel pressure sensor (FPS).

Specification: Refer to “Specification”

    Fuel Pump Control Module (FPCM) Schematic Diagrams
    Circuit Diagram ...

    Fuel Pressure Sensor (FPS) Description and Operation
    Description The fuel pressure sensor (FPS) is installed on top of the low pressure fuel pump and measures the pressure of the low pressure fuel line. Based on the current fuel pressure and the ...

    See also:

    Radiator Repair procedures
    Inspection Radiator Cap Testing 1. Remove the radiator cap, wet its seal with engine coolant, then install it to pressure tester. 2. Apply a pressure of 93 ~ 123kPa (0.95 ~ 1.25kgf/cmx, 14 ~ ...

    Interior light
    When the interior light switch is in the DOOR position and all doors (and trunk) are locked and closed, the room lamp will come on for 30 seconds if any of the below is performed. - When the door ...

    Fuse/relay panel description
    Inside the fuse/relay panel covers, you can find the fuse/relay label describing fuse/relay name and capacity. ✽ NOTICE Not all fuse panel descriptions in this manual may be applicable to ...

    Categories

    Hyundai Equus Manuals


    © 2011-2024 Copyright www.heqmanual.com