Replacement |
1. |
After loosening the mounting screw, then remove the hood latch release handle (A). |
2. |
Installation is the reverse of removal.
|
Specifications
Specifications
ItemSpecificationMaster cylinderTypeTandemCylinder I.D.25.4mm (1.00in)Piston stroke35±1mm (1.38in)Fluid level switchProvidedBrake boosterType8" + 9" TandemBoosting ratio9 : 1Front ...
Heater & A/C Control Unit Components and Components Location
Component
Connector Pin Function
Pin No.Connector A Function1Ground2Rheostat (Illumination -)3Rear Defog Switch4-5Detent Out (+)6HTD 7Illumination + (Tail)8-9Ground10-11Climate CAN High12 ...
Timing Chain Repair procedures
Removal
Engine removal is required for this procedure.
•
Use fender covers to avoid damaging painted surfaces.
•
To avoid damage, unplug the wiring connectors carefu ...