Intake Air Temperature Sensor (IATS) is included inside
Manifold Absolute Pressure Sensor and detects the intake air
temperature.
To calculate precise air quantity, correction of the air
temperature is needed because air density varies according to the
temperature. So the ECM uses not only MAPS signal but also IATS signal.
This sensor has a Negative Temperature Coefficient (NTC) Thermister and
it's resistance changes in reverse proportion to the temperature.
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the MAPS at idle and IG ON.
Specification: Refer to "Specification"
Removal
1.
Tur ...
Specification
TemperatureResistance (kx)°C°F-40-4040.93 ~ 48.35-20-413.89 ~ 16.030325.38 ~ 6.0910503.48 ~ 3.9020682.31 ~ 2.57401041.08 ~ 1.21601400.54 ~ 0.66801760.29 ~ 0.34
...
See also:
Pre-active Seat Belt (PSB) Description and Operation
Description
Pre-active Seat Belt (PSB) guarantees initial restraint
performance by winding the seat belt right before a crash or dangerous
condition and enhances the effects of the seat belt pr ...
Tire Repair procedures
Tire Wear
1.
Measure the tread depth of the tires.
Tread depth [limit] : 1.6 mm (0.063 in)
2.
If the remaining tread (A) depth is less than the limit, replace the tire.
  ...
Battery recharging by vehicle
After a jump start from a good battery, run the engine for 20-30 minutes at idle
or driving the vehicle before it is shutoff. Vehicle may not restart if you shut
it off before the battery had chan ...