Manifold Absolute Pressure Sensor (MAPS) is a speed-density
type sensor and is installed on the surge tank. It senses absolute
pressure of the surge tank and transfers the analog signal proportional
to the pressure to the ECM. By using this signal, the ECM calculates the
intake air quantity and engine speed.
The MAPS consists of a piezo-electric element and a hybrid IC
amplifying the element output signal. The element is silicon diaphragm
type and adapts pressure sensitive variable resistor effect of
semi-conductor. Because 100% vacuum and the manifold pressure apply to
both sides of the sensor respectively, this sensor can output analog
signal by using the silicon variation proportional to pressure change.
Inspection
Throttle Position Sensor (TPS)
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Start the engine and measure the output voltage of TPS 1 and 2 at C.T. and W.O.T.
Throttle ...
Specification
Pressure[kPa (kgf/cmx, psi)]Output Voltage (V)20.0 (0.20, 2.9)0.7946.7 (0.47, 6.77)1.84101.3 (1.03, 14.7)4.0
...
See also:
Components and Components Location
Component Location
1 . Front PAS sensor (4EA)2 . Rear PAS sensor (4EA)3. Indicator (warning information displayed on LCD)4 . Parking Assist System (PAS) switch5 . Body Control Module (BCM)6. Clus ...
Rear Stabilizer Bar Repair procedures
Removal
1.
Remove the rear wheel and tire (A) from rear hub .
Tightening torque:
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)
•
Be careful not to damage t ...
Timing Chain Components and Components Location
Components
1. Timing chain upper cover2. Timing chain upper cover gasket3. CVVT assembly4. Camshaft5. Timing chain lower cover6. Timing chain lower cover gasket(#1)7. Timing chain lower cover gas ...