Hyundai Equus: PGS Unit (Back & Blinde Unit) Repair procedures
Second generation VI (2009–2025) / Hyundai Equus VI 2009-2025 Service Manual / Body Electrical System / Parking Guide System (PGS) / PGS Unit (Back & Blinde Unit) Repair procedures
| Removal |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the glove box housing (A).
(Refer to Body - "Crach Pad")
|
| 3. |
Remove the glove box housing connector (A).
|
| 4. |
Remove the DIS head unit.
(Refer to Body - "DIS System") |
| 5. |
Remove the USB interface unit. |
| 6. |
Remove the PGS unit (A).
|
| Installation |
| 1. |
Install the PGS unit. |
| 2. |
Install the USB interface unit. |
| 3. |
Install the DIS head unit. |
| 4. |
Install the glove box housing. |
PGS Unit (Back & Blinde Unit) Schematic Diagrams
Circuit Diagram
...
See also:
Operating Door Locks From Outside the Vehicle
To lock the doors, press the button on the outside door handle while carrying
the Smart Key with you or press the Door Lock button on the Smart Key.
Put your hand in the driver’s outside door han ...
Auto Defogging Sensor Description and Operation
Description
The auto defogging sensor is installed on the front window
glass. The sensor judges and sends signal if moisture occurs to blow out
wind for defogging. The air conditioner control m ...
Components and Components Location
Component Location
1. Start Stop Button(SSB)2. FOB key3. Trunk open switch4. RF receiver5. Interior antenna 16. Interior antenna 27. Interior antenna 38. Trunk antenna9. Door handle & do ...
Categories
Hyundai Equus Manuals
© 2011-2025 Copyright www.heqmanual.com