>
Inspection |
1. |
Turn the ignition key to the "ON" position. |
2. |
Cover the front looking sensor to stop functioning. |
3. |
Head a light to the rearward looking sensor. |
4. |
The ECM should be darkened as soon as the rearward looking sensor detects the light.
|
5. |
When the reverse gear is engaged, the ECM should not be darkened.
When heading lights to both the front looking and rearward looking sensors, the ECM should not be darkened. |
Removal |
1. |
Remove the mirror wiring cover (A). |
2. |
Remove the connector (B). |
3. |
Push the inside rear view mirror base up to remove the inside rear view mirror assembly (A) after removing the screw.
|
Installation |
1. |
Install the mirror assembly. |
2. |
Install the mirror wiring cover and connector. |
Components and Components Location
Component Location
1. Start Stop Button(SSB)2. FOB key3. Trunk open switch4. RF receiver5. Interior antenna 16. Interior antenna 27. Interior antenna 38. Trunk antenna9. Door handle & do ...
Exhaust Manifold Components and Components Location
Components
1. Exhaust manifold heat protector2. Exhaust manifold3. Exhaust manifold gasket4. Exhaust manifold stay
...
Starter Components and Components Location
Components
1. Front bracket2. Planet gear shaft assembly3. Lever4. Lever packing5. Magnet switch6. Through bolt7. Planet gear 8. Shield9. Armature assembly10. York assembly11. Brush holder assemb ...