Hyundai Equus: Sedan Front Body
| Front body A |
|
|
|
| Roof panel front corner | Front pillar outer corner | Hood hinge mounting hole (O13) |
|
|
|
| Shockabsorber mounting hole (O24) | Front end module mounting hole (O9) | Cowl top cover mounting hole (O7) |
| Front body B |
|
|
|
| Hood hinge mounting hole (O13) | Front end module mounting hole (O9) | Fender apron panel tooling hole (O7) |
|
|
|
| Cowl top cover mounting hole (O7) | Front side member tooling hole (O8) | Front side member tooling hole (O11) |
|
| |
| Wiring harness mounting hole (12X16) | Wiring harness mounting hole (12X16) |
| Front body C |
|
|
|
| Fender apron panel tooling hole (O7) | Front side member tooling hole (8X8) | Front side member tooling hole (O7) |
|
|
|
| Front side member tooling hole (O8) | Front side member tooling hole (O11) | Wiring harness mounting hole (12X16) |
|
|
|
| Wiring harness mounting hole (12X16) | Front crash member bracket tooling hole (O9) | Front crash member bracket tooling hole (O9) |
General Information
General
1.
Basically, all measurements in this manual are taken with a tracking gauge.
2.
When a measuring tape is used, check to be sure there is no elongation, twisting or bending.
3.
...
Sedan Side Body
Side body A
Front side member tooling hole (O8)Fender apron panel tooling hole (O7)Front door hinge upper mounting hole (O13)Front door hinge lower mounting hole (O13) Fender mounting hole (O6.6 ...
See also:
Knock Sensor (KS) Description and Operation
Description
Knocking is a phenomenon characterized by undesirable
vibration and noise and can cause engine damage. Knock Sensor (KS) is
installed on the cylinder block and senses engine knockin ...
PGS Unit (Back & Blinde Unit) Components and Components Location
Components
...
Waist Line Molding Repair procedures
Replacement
•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply prote ...
Categories
Hyundai Equus Manuals
© 2011-2024 Copyright www.heqmanual.com