Four air spring solenoid valves (‘-’ control) and one
ambient solenoid valve are embedded inside this solenoid valve block as
shown in the circuit diagram below. When connecting the air tube to the
solenoid valve block, carefully check the color dot which is marked on
the valve and tube so that all colors should be matched each other.
The pressure sensor is built in the solenoid valve block so
that it detects the internal pressure when lifting or lowering the
vehicle height. Also it senses the pressure of reservoir tank every 30
minutes when the vehicle is running.
Components
1. Connected to air tube2. Bracket3. Connector
...
Circuit diagram
1.
Solenoid valve connector terminal
2.
Solenoid valve terminal function
TerninalFunction1Air spring valve FL2Ambiance valve3Air spring valve RR4Air spring valve RL5Solenoid ...
See also:
Operating Door Locks From Outside the Vehicle
To lock the doors, press the button on the outside door handle while carrying
the Smart Key with you or press the Door Lock button on the Smart Key.
Put your hand in the driver’s outside door han ...
Components and Components Location
Component Location (1)
1. Buzzer2. RF receiver3. Smart key unit4. Interior antenna 35. Interior antenna 16. Interior antenna 27. Trunk antenna8. Bumper antenna
Component Location (2)
1. Doo ...
Heated Oxygen Sensor (HO2S) Troubleshooting
Signal Waveform
Fig.1) The signal waveforms of front HO2S(the upper) and heater(the lower) at idle
Fig.2) The signal waveforms of rear HO2S(the upper) and heater(the lower) at idle
Fig.3) Typical ...