Initialization and Troubleshooting Procedures |
1. |
Initialization Procedure
: Disconnect (connector or battery) for 30 seconds (time required for internal condenser discharge), then reconnect the power. |
2. |
Troubleshooting Procedure
|
Heater Control Unit Components and Components Location
Control Panel
Component
Connector Pin Function
Pin No.Connector AConnector B1GroundIgnition 22-FET (Gate)3Mode Control Actuator (Vent)FET (Drain Feedback)4Mode Control Actuator (Defrost)Sen ...
Solenoid Valve Description and Operation
Description
Four air spring solenoid valves (‘-’ control) and one
ambient solenoid valve are embedded inside this solenoid valve block as
shown in the circuit diagram below. When connecting the ...
Front Door Module Components and Components Location
Component Location
1. Front door module
...