>
1. Check that the shift lever is in P (Park) and the Engine Start/Stop Button
is in the ON position.
2. Adjust the driver’s seat, outside rearview mirrors, steering wheel and HUD (Head-Up
Display) height to positions comfortable for the driver.
3. Press the SET button on the control panel. The system will beep once.
4. Press one of the memory buttons (1 or 2) within 5 seconds after pressing the
SET button. The system will beep twice when the positions of the driver's seat,
outside rearview mirrors, steering wheel and HUD (Head-Up Display) height have been
successfully stored.
Vehicle weight
This section will guide you in the proper loading of your vehicle, to keep your
loaded vehicle weight within its design rating capability.
Properly loading your vehicle will provide maximum return ...
High Mounted stop lamp Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the rear package trim (A).
(Refer to Body - "Interior trim")
3.
Remove the high mounted stop lamp (A) after removing sc ...
Wheel alignment and tire balance
The wheels on your vehicle were aligned and balanced carefully at the factory
to give you the longest tire life and best overall performance.
In most cases, you will not need to have your wheels al ...