Hyundai Equus: Tire Repair procedures
1. |
Measure the tread depth of the tires.
Tread depth [limit] : 1.6 mm (0.063 in)
|
|
2. |
If the remaining tread (A) depth is less than the limit, replace the tire.
When the tread depth of the tires is less than 1.6 mm (0.063 in), the wear indicators (B) will appear. |
|
Checking For Pull And Wander
If the steering pulls to one side, rotate the tires according to the following wheel rotation procedure.
1. |
Rotate the front right and front left tires, and perform a road test in order to confirm vehicle stability. |
2. |
If the steering pulls to the opposite side, rotate the front and rear tires, and perform a road test again.
Would not be applied, if have different front and rear tire. |
|
3. |
If the steering continues to pull to one side, rotate the front right and left tires again, and perform a road test. |
4. |
If the steering continues to pull to the opposite side, replace the front wheels with new ones. |
Wheel Alignment
When using commercially available computerized four wheel
alignment equipment (caster, camber, toe) to inspect the front wheel
alignment, always position the car on a level surf ...
See also:
Canister Repair procedures
Removal
1.
Turn the ignition switch OFF and disconnect the negative (-) battery cable.
2.
Remove the service cover (A).
3.
Disconnect the fuel tank pressure sensor connector (A) and the ...
Multi-view Camera Unit Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower pannel.
(Refer to Body - "Crash Pad Lower Pannel")
3.
Remove the Multi-view Camera unit (A) after di ...
Power Seat Motor Repair procedures
Inspection
Slide Motor Limit Switch
1.
Disconnect the limit switch (A) and operate the limit switch.
2.
Check for continuity between the terminals.
3.
Make sure that the seat operation is ...