>
Push the vehicle height control button to select the HIGH mode that makes the vehicle higher than the NORMAL mode and the indicator light on the vehicle height control button will illuminate. It is useful on a rough road.
✽ NOTICE
When you drive over 42 mph (70 km/h), you can not select the HIGH mode. If the vehicle speed exceeds 42 mph (70 km/h) while driving in the HIGH mode, the NORMAL mode will be selected automatically.
Push the vehicle height control button again to select the NORMAL mode that makes the vehicle height lower than the HIGH mode. The indicator light in the vehicle height control button will go off.
✽ NOTICE
This device complies with Part 15 of the FCC rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that
may c ...
Rear Seat Belt Buckle Repair procedures
Replacement
[Sedan 6:4]
1.
Remove the rear seat cushion assembly.
(Refer to Rear Seat - "Rear Seat Assembly")
2.
Loosen the mounting bolt, and then remove the rear seat belt buckle (A).
[L ...
35R Clutch Control Solenoid Valve(35R/C_VFS) Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the E Module connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the res ...