>
Replacement |
1. |
Turn ignition switch OFF and disconnect the negative (-) battery cable |
2. |
Remove the floor console.
(Refer to Body - "Console") |
3. |
Disconnect the yaw rate & lateral G sensor connector. |
4. |
Remove the mounting bolts (A).
|
5. |
Installation is the reverse of removal. |
Smart Key Receiver Repair procedures
Removal
1.
Disconnect the negatiev (-) battery terminal.
2.
Remove the glove box housing.
(Refer to Body - "Glove Box Housing")
3.
Remove the RF receiver (B) after disconnecting the conne ...
Air Lumber Support Switch Repair procedures
Inspection
1.
Disconnect the negative(-) battery terminal.
2.
Remove the shield outer cover.
(Refer to Body - "Front Seat Shield Outer Cover")
3.
Disconnect the power seat air lumber supp ...
Heated Oxygen Sensor (HO2S) Description and Operation
Description
Heated Oxygen Sensor (HO2S) consists of zirconium and alumina
and is installed both upstream and downstream of the Manifold Catalytic
Converter. The sensor output voltage varies in ...