The cluster ion generator makes disinfection and
decomposition of bad smell from the air-conditioner or inflow air. And
it cleans the inside air of a vehicle.
When the ignition switch is ON, the generator activates "CLEAN" mode and then "ION" mode, switching between both modes.
In the “CLEAN” mode, the cluster ion generator generates negative ions and positive ions to help clean smells from the air.
In the “ION” mode, the cluster ion generator generates negative ions and cleans inside air of a vehicle.
Inspection
To inspect and diagnose the sensor, refer to Self-Diagnosis procedure and DTC guide.
Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Using a screwdriver or remov ...
Inspection
1.
Press the MODE switch more then 4 times within 2 seconds while pressing the OFF switch.
DisplayFail description00Normal51Cluster ion generator fault
* For diagnostic procedur ...
See also:
Front Strut Assembly Components and Components Location
Components
1. Insulator cap2. Insulator assembly3. Spring upper pad4. Dust cover 5. Bump stopper6. Coil spring7. Spring lower pad8. Shock absorber
...
Repair procedures
Refrigerant System Service Basics
Refrigerant Recovery
Use only service equipment that is U.L-listed and is
certified to meet the requirements of SAE J2210 to remove
HFC-134a(R-134a) from the ...
Inhibitor Switch Specifications
Specifications
x Type: Combination of output signals from 4 terminals
Power supply (V)12Output typeCombination of output signals
Signal Code Table
PIN No.PP-RRR-NNN-DDS112V12VO ...