>
Hyundai Equus Manuals

Hyundai Equus: Door Scuff Trim Repair procedures - Interior Trim - Body (Interior and Exterior) - Hyundai Equus VI 2009-2024 Service ManualHyundai Equus: Door Scuff Trim Repair procedures

Second generation VI (2009–2024) / Hyundai Equus VI 2009-2024 Service Manual / Body (Interior and Exterior) / Interior Trim / Door Scuff Trim Repair procedures

Replacement
[Front Door Scuff Trim]
   
•
Put on gloves to protect your hands.
   
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Using a screwdriver or remover, remove the front door scuff tirm (A).

2.
Disconnect the front door scuff lamp connector (A).

3.
Install in the reverse order of removal.
   
•
Make sure the connector is connected properly.
•
Replace any damage clips.
[Rear Door Scuff Trim]
   
•
Put on gloves to protect your hands.
   
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Using a screwdriver or remover, remove the rear door scuff tirm (A).

2.
Disconnect the rear door scuff lamp connector (A).

3.
Install in the reverse order of removal.
   
•
Make sure the connector is connected properly.
•
Replace any damage clips.
    Door Scuff Trim Components and Components Location
    Component Location 1. Front door scuff trim2. Rear door scuff trim ...

    Cowl Side Trim Components and Components Location
    Component Location 1. Cowl side trim ...

    See also:

    Components and Components Location
    Component Location 1. Fuel filler door ...

    Air Lumber Support Switch Repair procedures
    Inspection 1. Disconnect the negative(-) battery terminal. 2. Remove the shield outer cover. (Refer to Body - "Front Seat Shield Outer Cover") 3. Disconnect the power seat air lumber supp ...

    Repair procedures
    Inspection Check it by the procedure below to see if the function of the ECM is normal. 1. Turn the ignition key to the "ON" position. 2. Cover the front looking sensor to stop functioning. ...

    Categories

    Hyundai Equus Manuals


    © 2011-2024 Copyright www.heqmanual.com