The A/C Pressure Transducer (APT) converts the pressure value
of high pressure line into voltage value after measuring it. By
converted voltage value, engine ECU controls the cooling fan by
operating it high speed or low speed. Engine ECU stops the operation of
the compressor when the temperature of refrigerant line is very high or
very low irregularly to optimize air conditioning system.
Replacement
1.
Remove the condenser.
2.
Remove the cap (B) on the bottom of the condenser with a L wrench (A).
Tightening torque :
2.7 ~ 3.1 N.m (0.28 ~ 0.32 kgf.m, 2.0 ~ 2.3 lb-ft)
...
Inspection
1.
Measure the pressure of high pressure line by measuring voltage output between terminal “1” and “2”.
2.
Inspect the voltage value whether it is sufficient to be regular value or ...
See also:
Erasing HomeLink® buttons
Individual buttons cannot be erased. However, to erase all three programmed buttons:
1. Press and hold the two outer HomeLink® buttons until the indicator light begins
to flash after 10 seconds.
2 ...
Rear Door Module Components and Components Location
Component Location
1. Rear door module
...
Repair procedures
Removal
1.
Remove the steering column upper and lower shrouds after loosening screws.
2.
Disconnect the multifunction switch connector (A).
3.
Remove the wiper & washer switch (A) by p ...