>
Removal |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the rear package trim (A).
(Refer to Body - "Interior trim") |
3. |
Remove the high mounted stop lamp (A) after removing screws. |
Installation |
1. |
Install the high mounted stop lamp to the rear package trim. |
2. |
Install the rear package trim. |
Special Service Tools
Special Service Tools
Tool (Number and Name)IllustrationApplicationCorrection jig of LDWS(09890-3N100)Correction of LDWS (Lane Departure Warning System)RKE Battery Checker(09954-2P100)Measuring t ...
Refrigerant Line Repair procedures
Replacement
1.
Discharge refrigerant from refrigeration system.
2.
Replace faulty tube or hose.
Cap the open fittings immediately to keep moisture or dirt out of the sys ...
35R Clutch Control Solenoid Valve(35R/C_VFS) Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the E Module connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the res ...